Cerart can be changed various surface to
Glazed Ceramic taste.
In case of ceramic tile and plywood, Dec
Multi-Seal ? 2 pack Epoxy primer might be
recommended as a primer between those substrate
and Cerart finish.
In case of using plywood as a substrate for
Cerart finish, you can create any authentic
shape easily and apply Cerart on it.
It can be recommend to use only for internal
wall as it might effect with water in case
of exterior use.
It also is recommended to apply on aged Ceramic
surface with Dec Multi-Seal, primer. Actually,
aged Ceramic tile is troublesome for the
renovation. You can adopt Cerart to resurface
on it without any hacking and replacement
of Ceramic tile.
In case of the substrate has steps, different
level, corner edge, profiles, joint in substrate,
etc., which are made of poured in concrete,
mortar itself, panel itself, etc., Cerart
Spray texture coating is a suitable for such
substrate. As it is thin finish, it makes
those shapes be sharpen on its surface such
as straight line, curves, corner edge, round
profiles, etc.
Free to design! You can create any joint
line in Cerart using Dec Tape JP, that is
a special masking tape for secured joint
line.
After the priming, Dec Primer, draw the guide
line and install the Dec Tape JP. And then
apply Cerart. It is easy and fast.
By details, please refer to the design tips
of Decrea stone texture coating.
Cerart application on Plywood
Cerart application on aged Ceramic tile